Roger, I am 61 and, not to jinx myself, healthy enough to where I expect that I will complete at least some of the projects in the queue before things go south. I do not harbor any false hope of getting them all done, though. To paraphrase my brother Pete, any new project I let in the front door just pushes one I already have out the back door.
But back now to fixing up a pair of CLW cast PAs, which is the current project (and one I hope to complete). If you have been following along, I have paired up a matching "all original" A and B unit and a similarly matched AA set for future assignments. That leaves two A units, which is what I need. First, unit #2:

As can be seen, somebody carved out the forward air intake but never got around to replacing it. Less obviously, they carved out the rear radiator vent on the sides and replaced it with a casting for this vent from a later CLW PA. It's a nice dress-up, but whoever did the work failed to get the piece flush with the car side. Also, you can still see the solder from a drip-rail over the cab side window. The drive is from a later CLW PA, but the truck side frames are original. This installation required a custom bolster assembly. The later frame is not a drop-in replacement for the original drive setup. The original modification to the shell to accept the new frame was not robust, so it will need some rework.
Finally, here is unit #4:

Note that the original side marker light housings have been partially cut down (the last bit to get them flush is the challenge). This unit came with an original drive, but one that is not in particularly good shape. As it is, I am in possession of a complete chassis from a later CLW PA. This chassis, which is shown with the unit in the photo above, has the earlier brass gearboxes, open-frame motor, and sprung trucks.
Here is an underside shot of these two shells:

Note the bolting flange between nose and roof on the left unit (bottom left of photo) is missing from the right unit, and that the solder job on the right unit is a good bit messier than the job on the left. All evidence suggests that the left unit (like its other clean-assembly brethren) is a factory-assembled shell while the shell on the right is a very early modeler-assembled shell.
So these units don't match each other nor do either match any other unit on the roster. That makes them good candidates for the T&NO or Cotton Belt assignments, which call for single units. One thing they will have in common though are missing dynamic brake units, as neither the T&NO or the Cotton Belt PAs had these. Machining these off the roof castings will be the next step.
Jim