Standard Gauge stuff

Standard Gauge Trains, Vintage to Modern
E7
Posts: 7353
Joined: Wed Dec 12, 2007 1:35 am

Re: Standard Gauge stuff

Postby E7 » Fri Aug 27, 2021 3:35 am

"This space for rent"

User avatar
healey36
Posts: 5160
Joined: Fri Sep 03, 2010 3:43 pm
Location: Westminster, MD

Re: Standard Gauge stuff

Postby healey36 » Fri Aug 27, 2021 2:28 pm

Found eight pieces of three-tie standard gauge track on eBay for five bucks (plus another ten for shipping). While I'm not sure of the manufacturer, it fits perfectly, so it might be early Lionel.

Image

I've seen folks use the center-span exclusively on a layout, Greg. It works pretty well, but you have to have a tailored place for it where it sits a bit below track-level. I took all of the standard gauge off my layout years ago, so this thing, if it ever gets used, will be on the carpet.

The next question is, how do you bend the track-pins so they have the correct angle for each section of bridge/track?

E7
Posts: 7353
Joined: Wed Dec 12, 2007 1:35 am

Re: Standard Gauge stuff

Postby E7 » Sat Aug 28, 2021 6:48 am

Healey, My first thought would be pliers with non-serrated (smooth) blades. You could also drill holes into hardwood (slightly larger than the diameter of the pins, to the depth where want the bend to be. Stick the pin in and bend away. There are any number of ways you could bring pressure against the pin at that point. Depends on how particular you are about the "cosmetics" of the pin.

Rich
"This space for rent"

User avatar
healey36
Posts: 5160
Joined: Fri Sep 03, 2010 3:43 pm
Location: Westminster, MD

Re: Standard Gauge stuff

Postby healey36 » Sat Aug 28, 2021 7:23 pm

I was just thinking of putting the pins in the bench vise and give them a few gentle raps with a hammer. Maybe I should rethink that, as your approach seems a bit more refined, lol.


Return to “Standard Gauge Trains”

Who is online

Users browsing this forum: No registered users and 1 guest