R.K. Maroon wrote:. I reviewed Bob's notes on setup and came up with a slightly different approach, which was to leave the universal joint in place and replace the ball-and-socket with a section of rubber tubing. I can report that the reputation of Toyota vacuum hose is intact -- it was just what was needed.
I recently purchased a non-running 0-4-0. The pictures showed there wasn't any connection between the gearbox and motor so I figured it would would be an easy fix, requiring about a 1.5 inch long piece of Toyota O tubing.
However, after receiving the 0-4-0, I realized there is nothing to hold the axle-mounted gearbox stationary relative to the frame - is that normal? Will the Toyota tubing by itself be enough to prevent the entire gearbox from rotating?